Products & Plans
- Rainwater Harvesting/Recycling Systems
- Stormwater Retention/Detention Systems
- Concrete Water Tanks
- System Controller Units
- Poly Water Tanks
- AQUAPLATE
Slimline Water Tanks - Pumps and Associated Fittings
- Industrial Stormwater Pollution Separators
- Commercial Recycling Systems
Components supplied as Standard on each system
- 1 x Rainwater Tank (Poly round or Aquaplate slimline above ground tank or Concrete below ground tank).
- Mains inlet connection point.
- House connection point.
- Automatic control for topping up of mains water to 25% capacity or Automatic control to switch to mains when tank reaches low water levels
- A draw off tank to reduce pump cycles.
- A site inspection with a recommended site-specific design.
- Diver /100 - 48 m/head stainless steel submersible pump.
- Control unit is mounted in an enclosure for easy installation.
Warranties
- 15 year warranty on the concrete tank.
- 12 month warranty on all electrical components.
- 5 year warranty on internal tank plumbing and fittings.
External connections not supplied by Rainmaster to and from the water tank
A licensed plumber is required to install the following to the relevant Australia Standards
- Connect the mains pressure line to the control unit.
- Connect the house connection to the dwelling.
- Connect the stormwater to the tank and overflow to the street or easement.
- Supply and install adequate backflow prevention device for crossover control unit.
- Install first flush devices to the selected downpipes.
- Excavate for the below ground system and place 1.6m3 meters of concrete around the system to prevent the tank from floating.
A licensed electrician is required to connect the following to the relevant Australian Standards
- Mains power to be connected to the external control unit.
- The control unit will be housed in an enclosure that will need to be mounted on the external dwelling wall as close as possible to the tank.
- Connect the power from the water tank to the Rainmaster control unit. (this requires 1 x 4 core cable for the pump & 1 x 2 core cable for the float switch) This can be laid in the same conduit.